User Guide DYMO Label Writer Label Printers

Label writer Printer Features:

Become familiar with the major components of the printer.

important
In order for the labels to feed properly during printing, pay attention to the following when loading labels on the spool and into the printer:

The label spool guide must be pushed flush against the label roll, with no gap. See Figure 2.

The labels must be loaded with the left edge of the label inserted against the left edge of the label feed slot. See Figure 4.

Figures 3 and 4 in this section show loading labels in a LabelWriter 450 printer. However, the

instructions apply to loading labels in any LabelWriter printer model.

To load a label roll

With the the printer plugged in, press the form-feed button to eject the labels that protected the printer during shipment. Open the top cover and remove any packing material inside the label compartment.
Remove the label spool from inside the cover and separate the spool guide from the spindle.

Hold the spool spindle in your left hand and place the label roll on the spindle so that the labels feed from underneath and the left edge of the label roll is firmly against the side of the spool. See Figure 1.

Slide the spool guide onto the right side of the spool and press the guide tightly against the side of the label roll, leaving no gap between the roll and the spool. See Figure 2.
Note to ensure proper feeding of labels during printing, the label roll must fit snugly against both sides of the label spool, with no gaps.
Insert the label spool into the slot in the printer cover with the labels extending from underneath the roll. See Figure 3.

Align the left edge of the label with the left edge of the label feed slot and insert the label into the slot. See Figure 4.

The printer automatically feeds the labels, stopping at the beginning of the first label. If the printer does not feed the labels, make sure the first label is fully inserted and then press the form-feed button.

If the first label on the roll is not a full label, press the form-feed button to eject the partial label.
Note Regardless of the label width, the left edge of the label must be aligned with the left edge of the label feed slot for the labels to feed properly.
(450, 450 Turbo, Duo, and Twin Turbo Only) Slide the label guide to the left until the label guide aligns with the right edge of the label. See Figure 4.
Make sure that the label guide does not pinch the label. (Twin Turbo Only) Repeat steps 3-8 to load a second roll of labels. Carefully lower the top cover.

Article ID: 699, Created: August 16, 2017 at 4:44 PM, Modified: August 16, 2017 at 4:49 PM

User Guide DYMO Label Writer Label Printers

Add Feedback

Was this article helpful?

Share this article